Publicidad
Idiomas disponibles
Idiomas disponibles
Antenna assembly:
1. Remove contents from the box.
2. Attach the stand to the back of
the antenna.
i. Be sure the coax cable is positioned
between the stand and the back of
the antenna.
ii. Slide the stand into the slots on
the back of the antenna until the
bottom of the stand is flush with the
bottom of the antenna.
iii. Push the coax cable into the channel on the bottom
of the stand until the cable is flush with the bottom of
the stand.
3. Remove the protective film from the face of the antenna.
Note: Antenna may also be mounted to a wall using the
keyholes on the back of the antenna.
Wall mounting
For best reception, you will likely want to mount the antenna
above your television. Please follow the instructions below for
proper wall mounting.
1. Purchase proper wall mounting hardware (drywall or
concrete anchors and screws)
2. Locate the tools below (tools not included). Some tools you
will need are:
i. Tape measure
ii. Pencil or pen to mark your holes
iii. Proper size drill bit (listed on the mounting hardware
that was purchased)
iv. Hammer
v. Screwdriver (that works with the mounting hardware
that was purchased)
3. Identify where you want to mount the antenna
4. Use your tape measure and a pencil, mark two places on
the wall exactly 14 ¼ inches apart
5. Use the correct drill bit (recommended by your purchased
mounting hardware) and carefully drill the two holes
marked in step 4
3
Publicidad
