Upright Operation - NUGENI STEAM+ SMP010 Guia Del Usuario

Upright Operation

Assemble Floor Mop
Note: Make sure unit is turned off before connecting mopstick.
Attach Handheld Unit to Mopstick
1. Insert steam port
of handheld unit
into steam inlet on
mopstick as shown.
1
Note: make sure power
cord is out of the way
(to the right side of the
mopstick) before trying
to attach handheld unit.
Attach Cloth to Diffuser Plate
1. Place steam floor diffuser base on top of cloth,
ensuring proper alignment of velcro tabs.
2. Fold long, straight velcro tab on cloth over
front edge of steam floor diffuser base and
press firmly along entire length to secure.
3. Pull cloth tight, then fold short, angled
velcro tabs over rear edges of steam floor
diffuser base and press firmly to secure.
Note: Improperly aligned cloth may interfere with mopstick + diffuser plate connection.
Attach Diffuser Base to Mopstick
1. Align steam floor diffuser base (with desired cloth
already attached) and bottom of mopstick.
2. Press down firmly, ensuring both connection
points "snap" together securely.
To Remove Diffuser Base:
3. Pull firmly to disconnect diffuser base when
finished.
12
2. Tilt handheld unit
back and press
firmly to "click"
securely in place.
"CLICK"
2
!
WA R N I N G
and allow a few minutes to
cool down before releasing
handheld unit from mopstick.
+
3
To Remove Handheld Unit:
3. Press up and hold
release switch on
back of mopstick.
4. Pull out the handheld
unit to remove.
Online
Help
Videos
1
3
mynugeni.com
Unplug
4
3
2
!
WA R N I N G
Turn steamer off
and allow to cool
before installing
or changing any
accessories.