Maintenance Plan; Replacing Blades - Zipper Maschinen ZI-HB204 Manual De Instrucciones

14 MAINTENANCE
Perform all maintenance machine settings with the machine
being disconnected from the power supply!
Serious injury due to unintentional or automatic activation of the
machine!
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Store the machine in a closed, dry location.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!

Maintenance plan

Inspections for the maintenance of the machine
Loose or missing screws
Damage to any part Daily before starting
Clean the machine Daily before starting
Inspection of blade
Cleaning of machine
After appro. 10 hours of operation we commend to lubricate the following parts: bearings of
the feed-in and feed-out rollers, bearings of pulley and gear wheel of the belt. Check

Replacing blades

 Unplug the planer-thicknesser from power source and turn the switch to "off" position.
 -Block the blade guard from closing down.
 -Loosen and remove blade lock screws securing blade and blade clamp.
 -Lift blade and blade clamp from cutterhead.
 -Clean any sawdust and resin buildup from cutterhead and blade clamp.
 -Place blade clamp against the replacement blade and replace in cutterhead.
 -Secure blade and blade clamp using three blade lock screws. Do not over-tighten blade
lock screws first.
Note: Check blade height at both of blade
 -Tighten blade lock screws.
 -Recheck blade adjustment and make sure blade is still level with outfeed table.
 -Repeat the procedure to replace the other blade.
 -Remove the scrap wood and release blade guard.
 -Make sure all the blade lock screws are tight and snug.
NOTE:
 -The blades which used with the tool may be replaced or re-sharpened.
 -If the blades are re-sharpened, the re-sharpenings should be not more than 3 times with
0.05mm max. each time.
 -the blades used in this tool can not be used to rebate.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HB204 24
A T T E N T I O N
N O T I C E
Daily before starting
Daily before starting
Daily before starting
Daily before starting
Daily after working
MAINTENANCE
24