N1108T-On/N1108P-On/N1108Ep-On; Installation; Mounting An N1108T-On/N1108P-On Switch Using Dell Tandem Tray - Dell N1108T-ON Guía De Introducción

N1108T-ON/N1108P-ON/N1108EP-ON

Installation

Mounting an N1108T-ON/N1108P-ON Switch
Using Dell Tandem Tray
The AC power connector is on the rear panel.
WARNING:
as well as the safety information for other switches that connect to or support the
switch.
WARNING:
table or desk, or attach it to a wall.
CAUTION:
Disconnect all cables from the switch before continuing. Remove all
self-adhesive pads from the underside of the switch, if they have been attached.
CAUTION:
When mounting multiple switches into a rack, mount the switches
from the bottom up.
1 Secure the N1108T-ON/N1108P-ON switch in the Dell Tandem Tray Kit
as shown in Figure 1-1.
Figure 1-1. Dell Tandem Tray Kit
2 Insert the switch into the 48.26 cm (19 inch) rack, ensuring that the rack
mounting holes on the kit line up to the mounting holes in the rack.
8
Getting Started Guide
Read the safety information in the
Do not use rack mounting kits to suspend the switch from under a
Safety and Regulatory Information