Publicidad
Idiomas disponibles
Idiomas disponibles
Fixture Operation
SLTA Series fixtures have 3 light configurations - Front Light on, Side Light on and Both Lights
on. Wave hand below the Wave Sensor on the fixture to automatically turn light on/off. See
Figure 5. The optimal distance to wave your hand is around 2 inches away from sensor. To
dim or brighten the light, hold your hand under the Wave Sensor. Remove hand when light
is at preferred brightness. This brightness level will be saved when light is turned off. To reset
brightness, you need to disconnect power supply and reconnect. See figure 4.
Wave Sensor Functions
First Wave: Turns front light on.
Second Wave: Turns front and side light on.
Third Wave: Turns front light off and side light on.
Fourth Wave: Turns all lights off.
Hold Hand Steady: Light dims or brightens until you move your hand away. This function
only works when front or side light is by themselves (First or Third Wave). It is disabled when
both are on (Second Wave).
Note: If fixtures are not working synchronously disconnect power supply to reset system and
plug in again.
©2017 AmerTac™
250 Boulder Drive
Breinigsville, PA 18031
www.amertac.com
Made in China / Fabriqué en Chine / Fabricado en China
I17-0057-A
FCC Statement
This equipment has been tested and found to comply with the limits for Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: Modifications to this product will void the user's authority to operate this equipment.
One-Year Limited Warranty
AmerTac warrants to the original purchaser that this product will be free from defects in materials
and workmanship for a period of one year from the date of purchase. Additional details are
available at www.amertac.com. PROP. 65 WARNING: This product contains chemicals known to
the State of California to cause cancer and/or birth defects or other reproductive harm.
Publicidad
