Seamaid 500743 Manual De Instalación Y Mantenimiento página 5

IMPORTANT : This instruction manual includes essential information on the safety measures to be
implemented for installation and start -up. It is important to read these instructions before beginning
installation and start-up. Keep this manual for future reference .
Failure to comply with the instructions given by the manufacturer in this manual regarding
installation, operational start up and maintenance of the product exonerates the manufacturer or the
distributor from any liability for damages affecting persons, the concerned prod uct or the other
installations, and shall void the guarantee .
1. VERIFY THE CONTENT OF THE PACKING

Radio remote switch

Antenna

Radio remote controller with battery

Installation and maintenance manuel
2. GENERAL CHARACTERISTICS
This radio remote switch has been designed for inside or outside use. It is a radio equipment
accessory, class III electric apparatus, with a very low safety voltage ~12V. It is recommended to be
used ONLY with the lighting systems of the SeaMAID range, working under the same voltage.
This radio remote switch complies with IP65 degree of protection.
This radio remote switch also complies with international safety standards for electric devises,
especially the IEC 61059 – 1 : 2002 +A2.
3. INSTALLATION
For a correct installation, the power socket which feeds the installation lamp will have to possess a
device of protection by residual current with a maximal intensity of 30 mA. This radio remote switch will
be only connected to a ~12V security transformer with double winding.
The maximum power of the one channel switch is 120W and the maximum power of the four channels
switch is 240W (120W per channel max).
The radio remote switch must be installed vertically against a smooth wall, antenna on the top of the
box.
To increase the radio signal, it is recommended to install the radio remote switch outside with a direct
view to the emitter.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any
electric components which have been inserted or handled at locations other than its own premises.
4. ASSEMBLY
Before any installation, it is important to verify that the total power of the connected projectors is lower
than the maxi power admitted by channel and by the radio remote switch.

Before installing this switch, ensures that the power supply is turn OFF.

Undo and remove the cover of the box

Fix the box vertically against the selected smooth wall with antenna base on the top

Screw the antenna on its base

Connect the 12VAC power cable from the transformer to the INPUT connector (1)

Connect the low voltage projector(s) on the corresponding channel

Restore the current

Proceed to the radio remote controller pairing

Replace the cover and re-screw it

Test all functions by pressing buttons O and X of each channel
5. MAINTENANCE
This radio remote switch does not require any type of maintenance work. When the red LED of the
remote controller does not light anymore, replace the 12V MN23 type alkaline battery.
In case of improperly working, please contact our customer service or the customer service of our
dealer.
ENGLISH