Herth+Buss Quicky 90A Manual De Instrucciones página 35

Operating Instructions
Using the Engine Start feature
Your battery charger can be used to jump-
start your car if the battery is low. Follow
these instructions on how to use the ENGINE
START feature.
IMPORTANT
Using the ENGINE START feature
WITHOUT a battery installed in the
vehicle could cause damage to the ve-
hicle's electrical system. NOTE: If you
have charged the battery and it still will
not start your car, do not use the EN-
GINE START feature, or it could dam-
age the vehicle's electrical system.
With the charger plugged in and connect-
ed to the battery and chassis (see section
6), press the CHARGE RATE button until
the ENGINE START
This product is rated for 3 seconds of
engine cranking.Crank the engine until
it starts or 3 seconds pass. If the engine
does not start, wait 3 minutes before
cranking again. This allows the charger
and battery to cool down.
NOTE: During extremely cold weather, or if
the battery is under 2 volts, charge the bat-
tery for 5 minutes before cranking the en-
gine.
35
LED is lit.
If the engine fails to start, charge the bat-
tery for 5 more minutes before attempt-
ing to crank the engine again.
IMPORTANT
Do not leave the charger in Engine
Start Mode for more than ten min-
utes at a time, or you may damage the
charger.
Clean and store the charger in a dry
location
NOTE: If the engine does turn over but never
starts, there is not a problem with the start-
ing system; there is a problem somewhere
else with the vehicle. STOP cranking the en-
gine until the other problem has been diag-
nosed and corrected.
95950003
EN