Controls And Indicators; Installation Instructions - Bentel Security VRP-433 Instrucciones De Instalación

The VRP-433 is a wireless repeater designed to extend the range of BENTEL SECURITY
one-way wireless transmitters and to improve signal quality between the transmitter and
receiver. Use the VRP433 to remedy transmission problems caused by excessive noise or other
interference, or by long distances between devices and receivers. The maximum recommended
number of VRP-433's per alarm system is 4.
Each enrolled VRP-433 occupies a zone slot. The VRP-433 does not increase the number of
supported wireless zones. This is determined by the control panel's wireless receiver. Only zones
requiring repeat functionality need to be enrolled on the VRP-433. Ensure these zones are enrolled on
both the VRP-433 and the receiver/control panel.
Unpacking
Ensure your package includes the following:
• One VRP-433 (rechargeable Ni-MH battery included)
• One direct plug-in transformer (Not included in all configurations)
• Mounting hardware pack, including plastic wall plugs and screws

• Installation instructions

Controls and Indicators

The VRP-433 has three LEDs on the front. The
meaning of these LEDs is different when in
normal operational mode (cover on) than when
in Installer mode (cover off). See the table
below for descriptions of LED functionality.
The wall tamper must be closed for the LEDs
to operate.
Table 1: LED Definitions
LED Normal Mode (cover on)
Green On: AC present
Flashing: No AC, battery good
Off: No AC and dead battery
Red On: Battery not connected
Off: Battery good (if AC on)
Flashing: Low battery
Yellow On: RF jam present
Off: No RF jam
Introduction
Figure 1: LED Indicators
Green
LED Installer Mode (cover off)
Green 1 flash: Enrolled
Flashing: Placement test active
Red Flashing: Zone not enrolled
X X
Yellow On: Repeater placement test "bad"
Off: Repeater placement test "good"
Flashing: Sporadic interference or valid
transmission packets detected
2
Yellow
Red