General Safety Rules; Personal Safety; Features - Urrea DM60 Manual De Instrucciones

GENERAL SAFETY RULES

WARNING: BE SURE to read and understand
all instructions in this manual before using the
product. Failure to follow these instructions
can create danger of exposure to radiation,
electric shock and / or injury.
Do not modify the operation of the
appliance in any way. This could give rise
to potential exposure to laser radiation.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE

PERSONAL SAFETY

WARNING: LASER RADIATION. Do not stare
into beam. Class II laser product. Turn the laser
beam on only when using this tool.
• The use of controls, adjustments, or the per-
formance of procedures other than those spe-
cified in this manual may result in hazardous
radiation exposure.
• The use of optical instruments such as, but
not limited to, telescope or transits to view the
laser beam will increase eye hazard.
• This measuring tool has a built-in laser light.
The laser is a Class II and emits output power of
a maximum 1mW and 635 wavelengths. These
lasers do not normally present an optical ha-
zard. However stare do not at the beam, as this
can cause flash blindness.
• The following label is on your digital laser
distance meter. It indicates the location from
which the digital laser distance meter emits
the laser light. Be aware of the laser light lo-
cation when using the tool. Always make sure
that any bystanders in the vicinity of use are
made aware of the dangers of looking directly
into the laser.
1. Do not remove or deface any product labels.
2. Always keep it out of the reach of children.
The laser light toward any person for any reason.
3. Do not operate the tool around children or
allow children to operate the tool.
4. Do not place the tool in a position that
may cause anyone to stare at the laser beam,
whether intentionally or unintentionally.
5. Do not use on surfaces such as sheet steel that
have shiny, reflective surfaces, the reflective sur-
face could reflect the beam back at the operator.
6. Always turn the laser tool off when not in use.
Leaving the tool on increases the risk of someo-
ne inadvertently staring into the laser beam.
7. Do not attempt to modify the performance
of this laser device in any way. This may result
in a dangerous exposure to laser radiation.
8. Do not attempt to repair or disassemble the
laser measuring tool. If unqualified persons at-
tempt to repair this product, serious injury may
occur. Any repair required on this laser product
should be performed only by authorized servi-
ce personnel.
9. Do not operate the tool in combustible
areas, such as in the presence of flammable li-
quids, gases, or dust.
10. Use of other accessories that have been de-
signed for use with other laser tools could re-
sult in serious injury.
11. Keep batteries out of reach of children.

FEATURES

The digital laser distance meter is a highly ac-
curate measuring tool for fast, easy operation.
A. Measure distances from 0.05 to 60m with an
accuracy of ±2mm.
B. The digital laser distance meter is intended for:
1) Measuring distance, lengths, heights, and
clearances
2) Difficult-to-measure situations: the Pythago-
rean Theorem mode allows indirect measure-
ment
3) Calculating areas and volumes
4) The automatic power-off function turns the
tool off after 5 minutes of inactivity for increa-
sed battery life.
1. LCD display-LCD display-Large LCD screen
with white back lighting helps makes it easy to
read the large-numeral measuring data clearly,
12