b
Follow the on-screen instructions to begin the Windows installation.
c
When prompted to specify a location for Windows, select Load Driver.
d
Insert the Adaptec Installation DVD, browse to the driver location, then click
OK.
e
When the driver is found, press Next.
Note:
With Adaptec Series 6 controllers, you may see the message 'No drives
were found'. Repeat
On the second attempt, the driver will load successfully.
f
Click Next again to accept the default partition configuration, or refer to your
Windows documentation to configure partitions manually.
g
Follow the on-screen instructions to complete the installation.
Red Hat Enterprise Linux 5
For Red Hat 6 or other Linux versions, refer to the Adaptec RAID Controllers
Installation and User's Guide on the Adaptec Installation DVD.
a
Insert the first Red Hat installation CD.
b
Restart the computer.
c
When the Red Hat Welcome screen appears, type
prompt.
d
When prompted, insert the driver disk, then select OK.
e
Follow the prompts to set up the environment you want.
f
If you are installing other third-party devices, install them now. Otherwise,
select Done.
g
Continue with the Linux installation, according to the Red Hat instructions.
Step 6
Install Adaptec Storage Manager
Before installing Adaptec Storage Manager, ensure that you are logged in with
administrator or root privileges. Any customization files you created using the
previous version are saved and used in the upgrade.
Windows Installation
a
Insert the Adaptec Installation DVD. Select Install Adaptec Storage Manager
from the DVD menu. The Installation wizard starts. (If it doesn't start, select
Browse the CD/DVD, then click Autorun.)
b
Follow the on-screen instructions to complete the installation. When
prompted to install SNMP (Simple Network Management Protocol), do not
install unless you have a specific requirement for Adaptec Storage Manager to
work with SNMP gets and traps.
Step
c,
Step d
(without reinserting the DVD), and
5
at the Boot:
linux dd
Step
e.