Vertilux VTi Celtic Manual De Programación página 10

Deleting a motor from all channels
Disconnect all motors from the power supply except the one you want to delete and follow this
procedure.
1. Press and hold the
until the the LED indicator on the motor starts
flashing RED.
2. Press and hold the programming button
7 s LED
about until the
flashes RED 7 times and then
This motor has been deleted from all channels.
Resetting the motor to factory default
This is convenient when there has been a programming mistake and the motor needs to be reset
to its factory default settings. It is not necessary to turn off all motors previously programmed in
the remote control.
1. Press and hold the
located on the head of the motor for about
LED
until the indicator starts flashing
quickly.
2.
Press and release the
again until the LED indicator flashes
time. All previous programming on the motor has
been deleted.
IMPORTANT: The values, recommendations and instructions in this manual may vary at any time without previous notice.
They are not contractual and can not be used as claim for defective merchandise, order cancellations or returns.
For additional information contact your Vertilux representative or Vertilux Authorized Dealer.
stop button for about 5 s
for
indicator on the motor
BLUE one time.
programming button
3 s
RED
programming button
BLUE one
STOP
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
9