Bosch GLM 50 C Professional Manual Original página 37

OBJ_BUCH-2450-006.book Page 37 Monday, December 18, 2017 12:17 PM
b) Double indirect Height Measurement (see figureC)
The measuring tool can indirectly measure all distances, which lie in the vertical level
of the measuring tool.
Select the double indirect height measurement
Measure distances "1" and "2" in this sequence as for a length measurement.
Upon completion of the measurement, the result for the sought dis-
tance "X" is displayed in the result line e. The measuring values for the
12.208 m
distances "1", "2" and the angle "α" are displayed in the measured-val-
-10° 10.154 m
ue lines d.
45.0°
8.765 m
Pay attention that the reference plane of the measurement (e.g. the
rear edge of the measuring tool) remains exactly at the same location
for all individual measurements within a measuring sequence.
c) Indirect Length Measurement (see figure D)
Select the indirect length measurement .
Pay attention that the measuring tool is positioned at the same height as the sought
measuring point. Now, tilt the measuring tool around the reference plane and meas-
ure distance "1" as for a length measurement.
Upon completion of the measurement, the result for the sought dis-
tance "X" is displayed in the result line e. The measuring values for the
20.000 m
distance "1" and the angle "α" are displayed in the measured-value
60° 60.0°
lines d.
10.000 m
Wall Surface Measurement (see figureE)
The wall surface measurement is used to determine the sum of several individual sur-
faces with a common height.
In the illustrated example, the total area of several walls should be determined, which
have the same ceiling height H, but different lengths L.
Select the wall surface measurement .
Measure the ceiling height H as with a length measurement. The measured value is
displayed in the top measured-value line. The laser remains switched on.
Then measure the length L of the first wall. The surface is automatically
1
calculated and displayed in the result line e. The last length measured
1.291 m
H
value is in the bottom measured-value line d. The laser remains
0.0° 2.583 m
L
switched on.
2.583 m
L
3.336 m 2
Bosch Power Tools
English | 37
.
1 609 92A 48U | (18.12.17)