Clone Tx Code; Bupc Functions In "Flor" Mode [ F ] - Nice MOU Instrucciones Para El Uso

3.1.15) 15 CLONE TX CODE [

Serves to change the original code of a transmitter connected to connector [2], copying it from another transmitter
read by means of readers [10] or [11] thereby obtaining two perfectly identical codes (cloning). Warning: since the
"Bio" system is based on the fact that each transmitter possesses a unique code, the possibility of having two or more
identical transmitters reduces the security of the system; for this reason the CLONE TX CODE function is not active
on all BUPC units; in addition, the operation can only be performed once on each transmitter.
Before activating the function extract exclusively the card from the transmitter on which you intend to change the code
and then insert the card into the specific adapter [12] and plug the adapter cable into socket [2].
This done, you can activate the function. This will be followed by a series of tests performed by the barrier controller
to check whether or not it is able to support the increased power consumption required by the function, terminating
with a test to confirm that the code has not already been changed. If all the checks produce positive results, the mes-
sage "Code:" will be displayed and the code optical reader will be activated; now you must approach the reader with
the specimen transmitter with one key pressed and the code will be copied by means of the optical reader onto the
transmitter inserted in the adapter.
4
3.2) BUPC functions in "FloR" mode [
This chapter contains an analysis of the functions of the BUPC programming unit in "FloR" mode
To execute several functions available in "FloR" mode the transmitter must be connected to the BUPC unit as
described in table 7 and as illustrated in figures 5.1 and 5.2.
Table 7: Connection of transmitters to BUPC
In "FloR" transmitters the card must be removed from
the plastic box and inserted into the specific adapter [12]
after having connected it to socket [2].
5.1
]
B
]
F
In "Very VR" transmitters the battery compartment must
be opened and connector [13] inserted into the specific
location after having connected it to socket [2].
5.2
GB
9