Bentel Security AMB10 Manual Del Usuario página 14

AMB10 - 15 - 20
5.4 AMB-TX 433 MHz Plug-in Radio Transmitter Card
Use this 6 digit serial number as ESN to configure both the
master element and the Slave element in the alarm system
The 433 MHz radio transmitter card has a 6 different signal transmission capacity if plugged onto the MASTER
barrier.
- ALARM
- END ALARM
- SUPERVISION
- FLAT BATTERY
- TAMPER
- TAMPER END
The same AMB-TX card allows the transmission of 4 different signals if plugged onto the SLAVE barrier
- SUPERVISION
- FLAT BATTERY
- TAMPER
- TAMPER END
Disconnect jumper for energy-saving LED cut-out, if desired.
Warning
The barrier detects its crossing if there is an interruption of the beams for a duration of 300 ms or 900 ms
depending on the FUNCTION dip-switch.
Based on this feature, the device is intended for use in security systems where an extremely rapid crossing of the
barrier, such as in access control situations, is not foreseen,
The range of the radio transmission could be affected by the installation of the barrier in proximity to metallic
fittings. If necessary, the best condition for the radio transmission can be found by moving the card with the
radio transmitter inside the aluminium profile, compatibly with the desired position of the beams
ENGLISH
J1: LED disabling jumper
14
ISFSLIMRFWL_05_08.doc