Steiner RANGER Serie Manual De Usuario página 10

EYEPIECE FOCUSING AND MAGNIFICATION
ADJUSTMENT
The ocular should be focused such that the reticle appears sharp
and black. Follow these two steps for quick and easy adjustment:
1
Point the riflescope at a bright surface (e.g. wall) and glance
through the riflescope. If the reticle appears already sharp and
black, no further adjustment is required.
2
If this is not the case, turn the diopter adjustment, until the
reticle is sharp and clear.
For distances less than 100 m, we recommend the use of a lower
magnification to avoid problems with simultaneous focusing of
image and reticle. To magnify, turn the magnification ring to the
left. To lower the magnification, turn the magnification ring to
the right. In the center position, the notch marks the 90° angle.
WINDAGE AND ELEVATION ADJUSTMENT
The windage and height adjustment for precise reticle
calibration is located behind the protective covers. The
reticle adjustments are calibrated so that 1 click corresponds
to 1 cm/100 m. The windage adjustment is located on the
right side of the riflescope and the elevation adjustment
on the top. Turn clockwise
(marked "UP") to move
the target point upwards.
Turn counterclockwise
(marked "DN") to move it
downwards. The windage
adjustment operates alike.
The individual clicks are
noticeable and audible.
Warning
Never use the riflescope to look at the sun or other bright
light sources! This will damage your eyes!
9