Turning On Bluetooth Audio; Active Noise Control; Call Feature; Making A Call - Marmitek BOOMBOOM 565 Modo De Empleo

TURNING ON BLUETOOTH AUDIO

Press and hold the Multi-function button for 5 seconds. The blue LED
light will start flashing rapidly.
The BoomBoom 565 will then automatically link to the last device it
was connected to. When connected, the blue LED lights will start to
flash at a slow rate. Only one device can be connected at the same
time to the BoomBoom 565. If your device does not connect
automatically, go to the device's Bluetooth settings and select the
BoomBoom 565. A connection will then be made.

ACTIVE NOISE CONTROL

Active Noise Control can be switched on or off using the NC switch. If
the green LED is on, Active Noise Control is activated.
Active Noise Control works completely independently from the audio
section. To ensure the best quality, NC even has its own power supply.
You may also use Active Noise Control with the BoomBoom 565's
Bluetooth audio section deactivated (to reduce ambient noise), or
while using the cabled BoomBoom 565.

CALL FEATURE

MAKING A CALL

When making a call from your mobile phone, the call will (depending
on the phone settings) be transferred to your headphones
automatically once a connection has been made.

ANSWERING A CALL

Press the Multi-function button [9] briefly to accept the call. The
music will be paused and the call will be transferred.

ENDING A CALL

Press the Multi-function button [9] briefly or end the call on your
phone. The music will continue to play automatically.
BoomBoom 565
9