Descargar Imprimir esta página

Blue Clean ECO 15 Traducción De Las Instrucciones Originales página 13

Aspirador de cenizas

Publicidad

Idiomas disponibles

Idiomas disponibles

Warning - danger!
Only suck in cold ash. See fig. 8.
Warning - danger!
Never suck in ash by inserting the tube into it. Never suck
in hot or red hot ash. Never suck in damp or wet ash.
See fig. 9.
7.2.2 Filter shaker See fig. 7b.
Filter shaker allow to shake the filter, in this way the dust
eventually attached on the filter wall falls down in the tank.
In this way suction capacity of your ash cleaner is always
at the top
- Set the starter device switch on (ON/I).
- Pull up and down 3 - 4 times the lever (A13) See fig. 7b.
- Starting for cleaning operations.
7.3
Stopping operation (Pauses)
Switch off the appliance. See fig. 6.
Connect the tube in the stowed position.
7.4
Finishing work
Switch off the appliance. See fig. 6.
Disconnect the plug.
7.5
Empty the tank
For dry dirt and dust: remove the nozzle from the appliance and empty
the tank. See fig 10.
8 MAINTENANCE (PAGE 6)
Warning - danger!
All installation and assembly operations must be performed with the appliance
disconnected from the mains power supply.
See page 6.
Always switch the appliance off and disconnect the plug before any servicing
or maintenance work. Repairs and work on electrical systems may only be
carried out by the authorised customer service.
Warning - danger!
Never use abrasive detergents, glass detergents or universal detergents!
Never immerse the cover of the appliance (A1) in water. Clean the appliance
and plastic accessories with a standard synthetic material detergent. Rinse
the tank and accessories with water if necessary and dry them before reuse.
8.1
Cleaning the EPA filter. See fig 11.
Open the vacuum-cleaner by releasing the catches (A6). Turn the
cover of the appliance (A1) upside down and remove the filter B1.
Rinse carefully under running water and leave to dry. Do not
reassemble until dry.
9 END-OF-SEASON STORAGE (PAGE 6)
Warning - danger!
All installation and assembly operations must be performed with the appliance
disconnected from the mains power supply.
After finishing work, clean the appliance and then put it and the accessories
away as shown. See fig 12.
Store the appliance in a dry place.
13
English

Publicidad

loading

Este manual también es adecuado para:

Mid 20Top 20