ION BLOCK ROCKER Guia De Inicio Rapido página 4

DIAGRAM AND PARTS DESCRIPTION
1. Instrument / Microphone Input with
Volume Control (1/4"):
input accepts a 1/4" input such as a
microphone, guitar, or other musical
instrument.
2. Auxuliary input
Volume Control (Stereo RCA): This
knob controls the level of the iPod and
the RCA input. This stereo RCA input
can be used to connect a CD, MP3, or
other audio source. To connect to a
portable device with a 1/8" headphone
jack, you need a standard (1/8" to
RCA) adapter which is NOT included.
3. Master Volume Control: This knob controls the master volume of the BLOCK ROCKER.
4. Radio Selector: This switch sets the radio to AM or FM or turns the radio off. (Note: This switch does not turn
the unit's power off – just the radio.)
5. LCD: Displays the current radio station.
6. Tuner: Use these buttons to search for a radio station. To "scan" (jump to the next available station), hold the
button down until it settles on the next station.
7. Power LED: Indicates whether BLOCK ROCKER is on or off.
8. Power Cable Input (IEC): Insert the included power cable here to charge the unit. Note that the BLOCK
ROCKER can run off the power adapter while it simultaneously charges the battery. The charge indicator
illuminates when the battery is charging.
9. Voltage Selector*: Set this to the correct voltage for
your location standard.
10. Power ON/OFF Switch: Turns BLOCK ROCKER on or
off. Please note that while BLOCK ROCKER is
connected to a power source, it does not need to be
powered on to charge the battery.
11. Battery Level Indicator: While the unit is powered ON,
these four lights indicate the power left in the battery. Battery life varies based on volume and usage.
12. Dock Charge Switch: Turn on iPod charging by setting this switch to the "Dock Charge" position.
IMPORTANT NOTES
Use this troubleshooting guide if: The sound is distorted at high volumes.
•
The sound is distorted: Try lowering the volume control of your sound source or music instrument. Also, try
to reduce the overall volume of BLOCK ROCKER.
•
There is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level.
This will allow you to play the music louder before clipping (distortion) occurs.
•
There is a high-pitched whistling noise when using microphones: This is probably feedback. Point the
microphones away from the speaker.
Important: With all large speakers, an initial "break-in" period is needed to perform at optimal levels. To
properly "break-in" your BLOCK ROCKER, play an audio source at medium volume for a few hours.
SPECIFICATIONS
Input Voltage: AC 100-120V/ 60Hz 220-240V/ 50Hz
Input Wattage: 50W
Output Wattage: (RMS) 18W, 1%THD, (Peak) 22W
Frequency Response (±3dB): (Aux) 90Hz-20kHz, (iPod) 77Hz-20kHz
Bottom pole mount specifications: Standard Pole Mount found at professional audio retailer:
Depth 80mm (3.15")
Diameter 35.5mm (1.40")
Time required to fully charge the BLOCK ROCKER: under 4 hours
Battery life: Over 12 hours* at full volume of the BLOCK ROCKER when fully charged.
*Note: Battery life may vary based on temperature, age, and volume usage of product.
This mono
with iPod/Aux
1
2
2
1
2
1
10
8
9
* WARNING:
switch to "100-120V" whereas U.K. and most
European users should set this to "220-
240V." Selecting the improper voltage can
damage the unit.
4
5
4
3
6 6
11
12
U.S. users should set this
7