Packaging; Remove Packaging; Controls - GE UNC15 Manual Del Propietario E Instrucciones De Instalación

Packaging

Remove Packaging

IMPORTANT: Do not remove any permanent
instruction labels inside your ice machine or the Tech
Sheet that is fastened behind the lower access panel.
To remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can
also be easily removed by rubbing a small amount of
liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.

Controls

1. POWER ON/OFF - Press to turn the ice machine on or off.
2. ICE MAKING - Glows white when the unit is ON.
3. CHECK WATER - Glows red when there is not water supplied to the machine.
4. TIME TO CLEAN - Glows yellow when it's time to clean the machine. The light will switch ON after 6 months of
use. It will remain on until the ice making system is cleaned using the process in the Care and
Cleaning section.
5. CLEAN RESET
49-1000436 Rev. 0
1 2
POWER
ICE
ON/OFF
MAKING
flammable fluids or abrasive cleaners to remove tape
or glue. These products can damage the surface of
Safety Instructions.
3 4
CLEAN
CHECK TIME TO
RESET
WATER CLEAN
5
5