Astro Tool 1756 Manual De Instrucciones página 2

1.) LUBRICATION:
Before connection of the hose, apply 4 to 5 drops of a good
quality air tool oil at the air inlet. After 3 to 4 hours of
operation, oiling may be necessary again.
2.) TIGHTNESS OF PARTS:
Regularly check whether all connection parts are
fastened securely. Follow this procedure daily
before beginning work.
3.) STORAGE:
Avoid storing the tool in a location subject to high humidity. If
the tool is left unused, the residual moisture inside the tool
can cause rust. Before storing and after operation, oil the tool
at the air inlet with a good quality air tool oil and run it for a
short period.
4.) DISPOSAL:
Follow national legislation of waste disposal.
5.) ORDERING SERVICE PART
For further operational and handling information or for
replacement of parts and components, contact the sales
agent from where you purchased the tool, or the service
division of our company, phone number 800-221-9705.
*When ordering parts and components, give each part
number, name, and quantities.
WARNING
Always wear ANSI approved safety goggles when using
this product. Normal use of this product is likely to expose
the user to dust and/or microscopic particles containing
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm. Always
wear approved safety equipment and clothing when using
this product. Study, understand, and follow all instructions
provided with this product.
a) Drill bits are extremely sharp and must be
handled with care.
b) Always keep hands and body away from drill bit.
c) Always disconnect air supply from tool prior to
replacing drill bit or servicing tool.
d) Failure to read and follow these warnings may
result in serious injury.
1756
AIR SPOT DRILL KIT WITH 5.5" DEEP
CLAMP AND 5 DRILL BITS
Page 2