Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WILL NOT SPRAY
There is no pressure on the gun. Check the
ducts and vents.
The fluid regulator is not open enough. Open
the fluid regulator.
Material too thick. Regulate dissolution or
change the system pressure supply.
OVER SPRAYING
Spray pressure too high. Reduce pressure.
Too far from the work surface. Accommodate
to the appropriate distance.
Inappropriate strokes. Try moving at a moder-
ate pace parallel to the surface.
LUBRICATION
1. Air filter.
2. Regulator.
3. Lubricator.
4. Emergency shut-off valve.
5. Hose diameter.
6. Thread size.
7. Coupling.
8. Safety Air Fuse.
9. Oil.
10. Grease (During assembly).
TECHNICAL DATA
NOZZLE DIAMETER
RECOMMENDED WORKING PRESSURE
CUP CAPACITY
AIR CONSUMPTION
AIR INLET
E N G L I S H •
AIR LEAKAGE THROUGH THE DEPOSIT WITH-
OUT PULLING THE TRIGGER
The trigger valve is stuck. Lubricate.
Contaminated air in the safety valve. Clean.
Trigger valve is damaged or worn. Replace.
Valve stem trigger is broken. Replace.
The valve is deformed. Replace.
48h
98 psi
PPG10
PPG13
1,0 mm
1,3 mm
22 PSI
36 PSI
100 ml
600 ml
7 CFM
10,6 CFM
1/4" NPT
1/4" NPT
U se r's m a n ua l
24h
PPG17
1,7 mm
29 PSI
600 ml
14 CFM
1/4" NPT
7
Publicidad
Tabla de contenido
