Additional Requirements; Step 1 -Attach Support Brackets To Base - Jiangsu Gardensun Furnace HSS-A-SS El Manual Del Propietario

WARNING
California Proposition 65
Combustion by products produced when using
this product contain chemicals known to the state
of California to cause cancer, birth defects, and
other reproductive harm.
Hardware
Picture Qty
3
6
6
6
3
6
6
2
4
9
9
9
9
3
3
1
4
Used in
Description Step(s)
Ground Fixer 1
1
Small Bolt
Small Flat
1
Washer
Nut
1
Medium Bolt 1
Large Bolt
2
Small Flange
2
Nut
2
3/16" Screw
5
Small Bolt
Small Screw 6
Large Flat
4 / 7
Washer
Small Flat
6
Washer
Cap Nut 6
Wing Nut 7
Reflector Stud 4
Wrench
1 / 2 / 5 / 6

Additional Requirements

The following items are not included, but are necessary for
. .
the proper assembly of your heater. Do NOT attempt to
. .
assemble without proper tools.
Philips screwdriver w/ medium blade.
Adjustable opening wrench.
Leak Detection Solution(Instructions on how to make
solution are included in step )
Note: You must follow all steps to properly assemble
heater.
For additional assistance or service,
please call: (855)885-5858.
Installation process
Step 1 – Attach Support Brackets to Base
To protect heater from strong wind, anchor
the base securely to the ground
with screws.
Reverse the base, fix the ground
fixer to the base with bolts and
washers like picture shows.
Secure the ground fixer with nuts.
Fix another two ground fixer with bolts and nuts,
and reverse the base. (Screws for anchoring
the base securely to the ground are not inculded)
.
Attach three Support Brackets loosely to Base with
three medium bolts downward through Support
Brackets into the Base.
3 Req'd Medium Bolts