Casals CTR305 Manual De Instrucciones página 10

SPECIFICATIONS
Voltage
Power
Protection Class
Degree of protection
Saw blade speed
Saw blade diameter
Dimensions (machine in packaging)
Maximum work piece cross section
0º x 90º
45º x 90º
0º x 45º
45º x 45º
Cutting capacities in the table saw
Gross Weight
Net Weight: (it must include all accessories)
Sound power Level L
WA
(according ISO 3744)
Sound pressure level at operator L
(according ISO 3744)
Effective value of weighted acceleration (vibration at handle)
INSTALLATION AND TRANSPORT
- Remove the box used to protect the machine
during transport and keep it intact for future
transport or storage.
- CAUTION Do not carry the machine by the han-
dle; the handle is not designed to bear the entire
weight of the machine. To carry the machine,
hold it on both sides of the base (12).
INSTALLATION (FIG.14)
- Lift the machine out of the box with the help of
another person.
- Turn rotating table into 0º position and tighten
the mitre lock.
- Note: If the machine is to be mounted on a
workstand, do not install the rubber feet.
- To install the rubber feet, carefully turn the
machine over to the right, so it is supported by
the motor.
- Fit the nut (A3) into the hole on the bottom of
the rubber foot.
- Insert the Allen head screw (A1) into the ma-
chine's foot from the top. Attach the rubber foot
(A2) with the previously inserted nut (A3) to the
screw.
PA
- Tighten the rubber foot hand-tight only.
- Tighten screw with the Allen key hand-tight only.
- DANGER! Risk of injury by incorrect handling
when lifting the machine or turning the machine
over. Always hold machine at the base (12).
- Place machine on a suitable surface:
- All four feet must firmly rest on the surface.
- The ideal height for the surface is approx
.800mm.
- The saw must stand securely, even when cut-
ting larger work pieces.
- Keep the packaging for future use, or separate
by material and dispose of in an environmentally
friendly manner.
TRANSPORT (FIG.5, 12, 13)
- Place the lower blade guard (14) from the left
hand side in front of the kerf plate's rear end
and push towards the rear.
- Swing sawhead down and engage the lock
down pin (22).
- Place the rip fence over the blade guard and
secure in position
- Lift the machine by holding it on both sides of
the base (12).
220-240 V~
S1 1600 W S6 25% 1800W
II
IP20
4000 min
-1
305 mm
710 x 585 x 470 mm
100x170 mm
100x118 mm
67x170 mm
62x62 mm
52 mm
26.5 Kg
22 Kg
105,5 dB(A)
92.5 dB(A)
1.74 m/s
2