ION PROJECTOR PLUS Guia De Inicio Rapido página 15

Listening to Music from an Auxiliary Device
You can play music from an auxiliary device (such as an iPod or other MP3 player) through
Projector Plus. You can play music from the auxiliary device while the projector is on and
operating or while the projector is off.
To play an auxiliary device through Projector Plus:
1. Use a standard 1/8" / 3.5 mm cable to connect the output jack on your aux device to the
Aux Input on Projector Plus.
2. Use the controls on your auxiliary device to play/pause a track, skip tracks, etc.
Note: If the sound from your auxiliary device is distorted, try lowering the volume on the
device. The volume on your auxiliary device should not be at full level.
Troubleshooting
If the unit is not charging: Make sure the power cable is properly connected to the power
input and the power outlet.
If the sound is distorted: Try lowering the volume control of your sound source, musical
instrument, or microphone. Also, try to reduce the overall volume of Projector Plus using the
Volume knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphone away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume
from your source.
If you cannot connect your audio device to Projector Plus via Bluetooth:
•
Have your audio device (e.g., smartphone or tablet) and Projector Plus as close together
as possible while trying to connect. Make sure both the audio device and Projector Plus
are unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Projector Plus to disconnect Projector Plus from any
other audio device and restart the search process. If this does not work right away, power
off Projector Plus and then power it back on.
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back
on. You can find this under the Bluetooth menu in the Settings for your phone or other
audio device.
If this does not work, and you have connected to Projector Plus before, find Projector Plus
in the list of available or previously connected devices in your audio device's Bluetooth
menu, tap the "gear" or "i" icon located next to it and then select Unpair or Forget. Turn
Projector Plus off and back on and try pairing again once it reappears in your available
devices list.
Note: If Projector Plus has been paired to another audio device recently that is still within
range, you may need to repeat this process with that audio device to fully disconnect.
15