Microphones, Guitar Cable - AKS WMS 40 SINGLE Modo De Empleo

2 Description
Note:
2.6.2 Microphones,
Guitar Cable
26
18 Audio input: 3-pin mini XLR connector with both mic and line level pins
that automatically match the connector pinout of the recommended
AKG microphones or optional MKG L guitar cable.
While the MKG L guitar cable is included in some WMS 40 SINGLE/
DUAL kits (see section 2.2 Unpacking), it is also available as an op-
tional accessory.
19 Antenna: Permanently connected, flexible antenna.
20 Belt clip for fixing the transmitter to your belt.
21 Battery compartment lid with integrated screwdriver (21a).
21b Viewing window: The viewing window lets you check if there is a dry
or rechargeable battery inside the battery compartment. You can also
insert a white lettering strip (supplied) or a color code strip (optional)
into the viewing window.
22 GAIN: This rotary control inside the battery compartment allows you
to match the bodypack transmitter input gain to the microphone or in-
strument you connected to the transmitter.
23 Carrier frequency label: The label on the transmitter rear panel indi-
cates the carrier frequency, color code (receiver channels with the same
carrier frequency are marked with the same color), and approval marks
of your transmitter. Refer to the Manual Supplement sheet for a color
code table.
The PT 40 PRO has been designed specifically for use with the following
AKG microphones:
The MKG L guitar cable from AKG lets you connect an electric guitar, elec-
tric bass, or remote keyboard to the bodypack transmitter. One or two MKG
L guitar cables, respectively, are included in the Instrumental Set Single
and Instrumental Set Dual. The MKG L guitar cable is also available sep-
arately as an accessory.
CK 55 L
C 417 L
C 420 L
C 444 L
WMS 40 SINGLE/DUAL