Accessories Supplied With The Unit; Installation Of The Unit - Technibel MCW1-2 Manual De Instalación

2.2 - ACCESSORIES SUPPLIED WITH THE UNIT

F
Accessory
1 - Support plate
GB
I
2 - Instructions
E
D
3 - Dowels
2.3 - WEIGHT
Net weight (kg)
MCW1-2
MCW3-4
MCW1-2
MCW3-4

3 - INSTALLATION OF THE UNIT

3.1 - CHOOSING THE LOCATION
• Select the location for the unit on the basis of the following
criteria:
- The device is intended for installation in sheltered premises
(IP 20). Do not install in very damp places or exposed to
projHigh speedections of water.
- Do not place above electrical sockets.
- The air intake and blowing grilles must be free from any
obstacle so that blowing can occur correctly in the whole
room.
- The wall on which the air handler will be fixed must be
sufficiently thick for there not to be any resonance and so as
not to produce any noise.
- Provide for the pipes and electric cables.
- It is essential to leave the clear space around the unit (see
drawing).
3.2 - INSTALLATION OF THE SUPPORT PLATE
• Remove the mounting
screw from the support
plate.
• Press at the points indicated
by a triangle to unhook the
plate's two lugs.
• The unit may be connected
at 5 different points:
- on either the right or left-
hand side,
- at either the right or left-
hand rear,
- on the lower right-hand side.
3
Q ty Use
1 Wall support for the unit.
2 Installation instructions.
Operating instructions.
6 For fixing the support plate.
Packed weight (kg)
10
8
14
12
A B
270 805
285 995
Accessory
4 - Screws
5 - Seals
6 - Remote control unit
2.4 - DIMENSIONS
C
C
177
206
- Do not install units with electric heating near combustible
materials or surfaces.
• Use the support plate as a jig to locate the rear outlets. Place
the plate level against the wall and mark the hole to be made.
For an outlet at the left-hand rear of the unit, use the plate's
most outside mark.
The Ø 65 mm hole in the upper right-hand corner of the
plate can also
be used thus
allowing the
tubes to exit
straight into the
wall.
• Mount the plate
on the wall
using the
s u p p l i e d
screws and
dowels.
To avoid vibrations, ensure that the panel is mounted securely
against the wall.
ty
Q Utse
For fixing the support plate
6
with the dowels.
2 Connection of flexible tubes
on the installation
(Ø 1/2" - 15 x 21)
1 Remote control unit
B
Ø 65 mm (MCW1-2)
NO YES
111
NO