Descargar Imprimir esta página

Sears 358.799211 Manual Del Usuario página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
(If tool is received
assembled,
repeat
all steps
in this section
to be sure assembly
is correct
and is ad-
justed
for the operator.)
A. PREPARATION
This Oparator's Manual
is designed
to help you as-
semble the tool and to provide its safe operation.
It is
important that you read the entire manual to become
familiar with the toolbe/ore you begin assembly. If
you have any _estions or need _er
assistance,
callour CUSTOMER
ASSISTANCE
HOTLINE
at
1-800-235-5878.
,,,,,,,,,,,,,., , ,,,
i
,,,,,,.,,
1.Read your Operator's Manual
2.Tools you willneed:
- Hex Wrench providedwith thetool.
- Adjustable Wrench
- Standard Screwdriver
- Phillips S crewdriver
i l
ii
Hardware
referred to in the following sections
is shown actual size in the Hardware
Chart, page 5.
I. TUBE
(Figure 1 )
a. Insext screwsA. and nuts D. inthe nose cone.
Figurei. Tighten with the hex wrench (pro-
vided) justenough to held partstogether.
b. Remove thepacking cover from the straight
end of the tube if so equipped.
Make sure the drive shaft does not fall out
of the tube. Dirt on the shaft will significantly
re-
duce the life of the tool. If the drive sha_ falls out
of the hous_
dean,
re-lubricate, a nd re-ins-
tal!. See the
Drive ShaftLuhricatlon"
section.
Before performingstep
c., it might be nec-
essary to loosen the throttle grip screws.
c. Insert the tube through
the throttle grip as
shown in Figure 1.
d. Align the groove on the tube with the ridge on
the inner, lower wall of the nose cone opening.
Figure 1.
e. Firmly push the tube into the nose cone open-
ing until the bold Rue on the decal is not vis-
ible. Make sure the drive shaft is eng_ed
by
pulling the starter rope; if the arbor shaft does
not turn, reinstall
the tube in the nose cone.
fi Tighten the nose cone screws until secure.
g. Slide the throttle grip toward
the engine until
it contacts
the nose cone.
Then, tighten
the
throttle grip screws until secure.
Drive
Shaft
BoldLine
On Decal
Throttle
Grip
/
Nose Cone
Ridge
Groove
Throttle
Nuts D.
Cable
Tube
Arbor
ShafL----_
Figure i
NOTES
-6-

Publicidad

loading