System Flush - Beissbarth BAC 4100a Instrucciones Originales

Operating Instructions — System Flush

System Flush

The SYSTEM FLUSH function is performed using a
vehicle manufacturer-approved flushing adapter. Refer
to the instructions included with the adapter also as you
perform the following steps.
1. Verify the flusher filter and strainer are not plugged.
2. Mount the flusher to the rear of the Beissbarth
machine. Do not make any connections at this time.
3. Remove oil drain bottle (see Figure 10) from the
Beissbarth machine. Drain the oil bottle, and
dispose of oil according to regulations for your area.
4. Recover all refrigerant from system to be flushed.
5. Note the amount of oil collected during recovery.
This amount must be replaced, as well as any oil
collected during flush.
Note: The amount of oil collected and reported
during System Flush does not include the amount
of oil collected during the initial recovery.
6. To complete an effective system flush, verify the
Beissbarth machine has at least 5.9 kg (13 lb.) of
chargeable refrigerant in the ISV.
Note: If the machine does not have at least 5.9 kg
(13 lb.) of refrigerant on-board, see the section of
this manual titled Tank Filling.
7. Disconnect the Beissbarth machine from vehicle.
8. Refer to the vehicle service manual, and connect
the appropriate flushing adapters and bypasses.
9. Connect the low-side (blue) service hose directly to
the filter of the flushing kit.
10. Remove the high-side (red) service coupler, and
connect the high-side (red) service hose to the
system suction line adapter.
11. Use the supplied hose to connect the system
discharge adapter to the flusher inlet.
12. Connect hoses according to the instructions
included with the flush kit.
22
WARNING: To prevent personal
injury while working with refrigerant,
read and follow the instructions
and warnings in this manual, and
wear protective equipment such as
goggles and gloves.
Oil Drain
Bottle
Figure 10