Tuner; Tuning To Radio Stations; Switching Fm Sensitivity; Storing Radio Stations - Magnavox MFX-450 Guia Del Usuario

MFX450_eng 11/26/02 3:21 AM

Tuning to radio stations

You can search for radio stations by scanning the frequency
band. You can also key in the frequency of a known radio
station. If an FM station is being broadcast and received in
stereo, is shown.
STEREO
Searching for radio stations
1 Turn SOURCE SELECT to select the tuner.
TUNER is displayed.
y
2 Select a waveband by pressing TUNER BAND repeatedly.
y The selected waveband is displayed.
3 Keep 1 or 2 pressed for approximately 1 second.
SEARCH is displayed and the tuner tunes to a station
y
with sufficient strength.
4 Repeat this procedure until you find the desired station.
• To fine tune to a weak transmitter, briefly press 1 or 2 as
often as necessary for optimum reception.
Tuning to a radio station by frequency (with the remote
control only)
1 Press TUNER.
TUNER is displayed.
y
2 Press FR. D..
_ is displayed.
y
3 Use 1–0 to key in the frequency of a radio station.
Notes: Only valid numbers within the frequency range of the
tuner can be keyed in.

Switching FM sensitivity

You can switch the tuner to a lower search sensitivity, to
search only for stations with a strong signal (FM only).
1 Turn SOURCE SELECT to select the tuner.
TUNER is displayed.
y
2 Press SENS. on the receiver.
Either
y
SENS HI
Note: While searching for radio stations, the actual sensitivity
is displayed. In this case,
looking only for radio stations with a strong signal.
Page 23
or is displayed for 5 seconds.
SENS LO
means the tuner is
SENS LO

Storing radio stations

You may store up to 30 radio stations in the memory. The
receiver can select and program radio stations by itself or you
can choose them yourself.
Automatic programming
1 Choose * TUNER from the menu and press NEXT 2.
2 Choose AUTO INSTALL and press NEXT 2.
The preset number where programming will start, the
y
waveband and AUTO are displayed.
3 Turn TUNER PRESET X to change the preset number where
programming should start.
4 Use TUNER BAND to switch to the desired waveband.
5 Press ENTER / OK to start programming.
AUTO INSTALL flashes and all available radio
y
stations are programmed, this may take a few minutes.
Programming is done when AUTO INSTALL stops
flashing.
Manual programming
1 Choose * TUNER from the menu and press NEXT 2.
2 Choose MAN INSTALL and press NEXT 2.
y A preset number, the waveband and the frequency are
displayed.
3 Turn TUNER PRESET X to change to the preset number
where the radio station should be stored.
4 Tune to the desired radio station (see "Searching for radio
stations").
5 Press ENTER / OK to confirm your selection.
STORED is displayed briefly. The radio station is
y
programmed at the chosen preset number.
6 Select and store all desired radio stations this way.

TUNER

23