Installation And Use - AllPondSolutions All-in-one cup-311 Manual Del Usuario

INSTALLATION AND USE

1) Open the CUP-311 by unfastening the casing clips (parts 4) and
removing the filter casing (part 3).
2) Remove the filter baskets (parts 8) from the CUP-311 and clean
through the included media and coarse foam (part 5) with some
pond water (away from your pond).
3) Reassemble the CUP-311.
4) Attach the desired fountain attachments / outlets to the CUP-311
outlet connection point (see parts diagram for fountain assembly).
5) Decide on the position of the CUP-311 in your pond and check that
the power cable will reach your power supply.
6) Wire the CUP-311 to your power supply (see ELECTRIC section of
manual) – DO NOT supply power to the CUP-311 yet.
7) Place the CUP-311 in your pond and position on a flat even surface.
8) Switch on the power to the CUP-311 at your power supply.
OPERATION