Table of Contents
- - - - - - - - - - - - - - - - - 2
- - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - 3
- - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - 4
- - - - - - - - - - - - - - - - - - 4
- - - - - - - - - - - - - - - - - - - - - - - - - - - 4
- - - - - - - - - - - - - - - - - - - - - - - - 4
- - - - - - - - - - - - - - - - - - - - - - - - 4
- - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - -
1
- - - - - - - - 1
2
2
2
3
3
- - - - - - - - - - - - - - -
3
5
5
5
5
5
5
6
- - - - - -
6
- - - - - - -
6
6
LASER DISTANCE MEASURE
Important Safety
Instructions
Do not use the product before you
have studied the User Manual.
The product is permitted to use for skilled persons
only.
CAUTION:
Use of controls or adjustment or performance of
procedures other than those specified herein may
result in hazardous radiation exposure
WARNING:
•
It is a Class 2 laser product in accordance
with IEC 60825-1:2014
IEC 60825-1: 2014
<1.0mW @ 620-690nm
Laser radiation. Do not stare into beam. Class 2 Laser
product. Complies with 21 CFR 1040.10 and 1040.11
except for deviations pursuant to Laser Notice No.50,
dated June 24, 2007
•
Do not attempt to modify the performance of
this laser device in any way. This may result
in a dangerous exposure to laser radiation.
•
Do not operate the tool outdoors.
09-25466
•
Do not attempt to repair or
disassemble the laser-measuring
tool. If unqualified persons attempt
to repair this product, serious injury
may occur. Any repair required on
this laser product should be
performed only by qualified service
personnel.
•
Do not stare into the laser beam or
direct it towards other people
unnecessarily.
•
Don't aim device at your own or
another person's eyes.
•
Looking directly into the beam with
optical aids can be hazardous.
•
Do not operate the product in
explosion hazardous areas or in
aggressive environments.
•
Only use chargers recommended
by the manufacturer to charge
the batteries.
•
Watch out for erroneous
measurements if the product is
defective or if it has been dropped or
has been misused or modified.
•
Carry out periodic test measurements.
Particularly before, during and after
important measurements.
•
The product and batteries must
not be disposed of with household
waste.
1