Novellini 127640 Manual De Instalación, Uso Y Mantenimiento página 5

that the product complies with current health and safety standards. All items
and components are factory tested according to reference standards and in-
house quality procedures. To ensure that the bath continues to be safe even
after installation and throughout its useful life, check the following:
1) The electrical system to which the bath is to be connected must conform
with current regulations and standards. Remember that the system must be
properly earthed.
2) All electrical fittings (power outlets, switches, etc) must be at least 60 cm
from the bath or at a height of 225 cm.
3) The power supply line must be suitable for the power requirement of the
bath (see technical specifications, page 17).
4) The point where the bath is connected to the electrical system must be
suitably protected against splashing water (degree of protection IP55 or
greater).
5) The whirlpool system must be fitted with a 30 mA switched circuit breaker
with a minimum contact opening of 3 mm.
6) The bath frame has an earth terminal that must be properly connected to the
earthing system of the supply circuit,
7) The whirlpool baths is provided with electrical connection of the type Y, if
the power cord is damaged, it must be replaced by the manufacturer or by its
technical assistance service or in any case a person with similar qualification,
so as to prevent any risk.
(refer to illustrations on page 18).
equipotentiality
-5-
ENGLISH