Monogram ZDT915 Serie Manual De Instrucciones página 8

Control
5
Settings
8
Select Options
The light by the selected button will be lit to indicate which Option has been selected.
Normal This option is for normally soiled dishes, optimizes wash performance while
Temp conserving energy.
Boost This option increases the temperature to help clean heavily soiled dishes and
Temp will increase the cycle time by 20 to 50 minutes. Option may be turned On or
Off during the wash cycle. This option will also improve dry performance on the
Normal cycle.
Sanitize This option raises the water temperature in the final rinse to sanitize your
Temp dishware but may increase cycle time by 60 minutes. The cycle length will vary
depending on the temperature of your inlet water.
NOTE: This option is monitored for sanitization requirements. If the cycle
is interrupted during or after the main wash portion or if the incoming water
temperature is so low that adequate water heating cannot be achieved, the
sanitizing conditions may not be met. In these cases, the Sanitized light will not
illuminate at the end of the cycle. Utilizing this option will modify the cycle to meet
the requirements of Section 6, NSF 184 for soil removal and sanitization efficacy.
NOTE: NSF certified residential dishwashers are not intended for licensed food
establishments.
Power Dry Shuts off the drying option. Dishes air dry naturally and energy is saved. Open
Off the dishwasher door to speed drying.
Power Dry Turns on the option for faster drying. This option may add up to 85 minutes to
On the cycle time. On models with the hidden heater feature, this option boosts
the temperature of the dishwasher during the final rinse portion of the cycle
then utilizes a fan to circulate air to dry the dishes. This very efficient fan may
run for an additional 90 minutes after the cycle is complete to maximize drying
performance. Fan operation will end if the door is opened during this 90 minute
period. This option is not available with the Rinse cycle.
Max Dry For improved drying performance by running the fan at high speed. This option
may add up to 125 minutes to the cycle time. This option is not available with
the Rinse cycle.
Pre Soak Use this option to improve wash performance with heavy or dried-on soils. This
option is available on Heavy, AutoSense, and Normal cycles and may add up
to 30 minutes to the cycle time.
Wash Selecting either the Upper or Lower Wash Zones will target dishwashing of
Zones just one rack. This will shorten the cycle time and conserve energy. This option
should be used when dishes are placed in only one rack.
Bottle Jets This option increases the time that the bottle jets are on and may add up to 23
minutes to the cycle time. Use this to wash difficult to clean, dishwasher safe
baby bottles, sport bottles, tall coffee cups, etc. See use recommendations in
the Loading the dishwasher
Delay Delays the start of a wash cycle up to 8 to 12 hours depending on model. Press
Hours DELAY HOURS, to select the number of hours, then press START one time and
close door to begin countdown. The cycle will start once allotted time has expired.
Control You can lock the controls to prevent selections from being made. You can also
Lock lock the controls after you have started a cycle to prevent cycle changes. For
example, children cannot accidentally start the dishwasher by pressing buttons
with this option selected.
To LOCK the dishwasher control, press and hold both the Pre-Soak and
Bottle Jets buttons for 3 seconds. The Control Lock light will turn on to
indicate the control is locked.
To UNLOCK the dishwasher control, press and hold the Pre-Soak and
Bottle Jets buttons for 3 seconds. The Control Lock light will turn off to
indicate the control is unlocked.
Control Panel/Operation
Dishwasher
section.