Start-Up Procedure - Tetratec EX 400 Manual De Instrucciones

7
Installing the Flow Return Pipes
13
Suction Cup Clip
14
a) Example of use: Long Clip
Note: Extra suction cups and each type of clips are enclosed. Use them in accordance to your tank and your
tank set up.
8
Assembling Water Hoses
15
OUT = Return
9

Start-up Procedure

16
Set up
Affix the assembled overflow pipe, spray bar and stopper to the
wall of the tank using the suction cup clips.
Spray bar
Adjust the length of the spray bar to the width of the tank. Use only one flow
return pipe for tanks that are relatively narrower in width. Remove the stopper
to decrease water pressure in the spray bar.
Stopper
b) Example of use: Short Clip
Connect the intake hose to the hose adaptor marked "IN".
Connect the hose to the water intake pipe and to prevent leakage
tightly secure the hose with the screws.
Connect the flow return hose to the hose adapter marked "OUT".
Connect the hose to the flow return pipe and tightly secure with
the screws.
Note: Cut the hose to the length required.
IN = Intake
Open the valves of the hose adaptor. Turn the valves parallel to the
hose adapter as shown.
21