Caution Utility Services; Original Accessories / Attachments; Before First Use; Mounting Or Adjusting The Additional Handle - Parkside PSB 1050 A1 Instrucciones De Utilización Y De Seguridad

General safety advice for electrical power tools / Before first use
½
If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback.
½
Always keep the device clean, dry
and free of oil or grease.
½
When carrying out work during which
the insertion tool could hit hidden
power cables or the power cable of the
appliance itself, hold the appliance by
the insulated handling surfaces. Contact
with a live cable can also make metal appliance
parts alive and cause an electric shock.
½
Keep your workplace clean and tidy.
Mixing materials is particularly dangerous.
Dust from light metals can burn or explode.
½
Wait until the electrical tool has come
to a standstill before putting it down.
The insertion tool could get caught up in some-
thing and this may lead to control of the electrical
tool being lost.
©

Caution utility services!

DANGER! Ensure that you do not strike
electrical cables, gas or water pipes when
you are working with the electrical power
tool. Check a wall using a suitable detector before
you drill or cut slots.
©
Original accessories /
attachments
Use only the accessories and attachments
detailed in the operating instructions.
The use of inserted tools or accessories other than
those recommended in the operating instructions
could lead to you suffering an injury.
©
Before first use
DANGER OF INJURY!
Switch the device off and pull the plug out of the
mains socket before carrying out any work on the
device.
40 GB/MT
©
Mounting or adjusting
the additional handle
NOTE: For reasons of safety, you may only use
this appliance with a properly mounted additional
handle .
10
Turn the wing screw
mount the additional handle
position. The ratchet settings have be pushed
over the two green locking pins on the spindle
neck of the appliance.
Tighten the wing screw
wise.
NOTE: Adjust the additional handle
various ratchet settings according to the position
you are working in. To do so, loosen and close the
additional handle as described above.
©

Using the depth stop

Loosen the wing screw
Pull the depth stop
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
Firmly tighten the wing screw
©

Inserting tools

Quick - action drill chuck / spindle lock:
Your percussion drill has a fully automatic spin-
dle lock and is fitted with a single - sleeve
drill chuck with radial lock "Made in Germany"
by .
When the motor comes to a standstill, the drive
train will lock so that you can open the quick -
action drill chuck
1
After you have inserted the tool you wish to
use, turn the drill chuck
hear any more clicks. The drill chuck will lock
automatically. The spindle lock releases itself
automatically when the motor is started (by op-
eration of ON / OFF switch
anti - clockwise and
9
in the vertical
10
by turning it clock-
9
into the
10
.
9
8 out as far as necessary
9 .
by turning it .
until you cannot
).
4