Troubleshooting - Vision SP-1800 Manual De Propietario

3. TERMINATE CABLES TO LOUDSPEAKERS Connect speaker cables from amplifier to screw
terminals on rear of loudspeakers. Use unshielded speaker cable with gauge of 0.75mm or
higher.
4. TIGHTEN BRACKET SCREWS Set desired angle and lock off side screws.

TROUBLESHOOTING

If your system is not operating properly, please refer to the following information. If the
problem persists, disconnect from power and contact your AV reseller immediately.
Problem
Sound only coming out
one side
Sound very quiet
Correction
Turn off amplifier and switch output connections. If the side
•
changes the amplifier is okay and the fault is with one of the
loudspeakers.
Switch input connections and check input cabling.
•
• Have you used unshielded speaker cables? Use cable with
gauge of 0.75mm or higher. Note: Phono or minijack cable is
shielded and is not appropriate.
5
SP-1800_manual_en.doc