Reset To Factory Settings - EVERSPRING AN132 Guía De Usuario

Reset to Factory Settings

To reset AN132 back to factory default state:
1. Press and hold the On/Off button for 3 seconds until the LED starts to flash then
release the button.
2.
Within 30 seconds, press and hold the button for more than 6 seconds. The LED
will start to flash, implying the device is reset back to factory mode
Troubleshooting
The troubleshooting table lists some possible causes and solutions. Please contact
your original retailer or nearest service center if the below solutions cannot solve your
problem.
Symptom Cause of Failure
1. The unit is not connected
well to the power socket or
The unit is not working and
extender.
LED is off.
2. The unit is out of order.
The unit is working, but
Check if the device connected
cannot control the ON/OFF
to the unit has its own on/off
status of the device
switch.
connected to the unit.
1. The unit didn't complete
successfully the binding
The LED is on but cannot operation.
control the unit. 2. The unit cannot
communicate with the
gateway HSC04.
The LED flashes rapidly for
30 seconds and the unit Overload occurred.
cannot be controlled.
LED Table
The table below describes the LED indication at various stages of Plug operation.
Recommendation
1. Try to connect again and
make sure the extender is
working fine.
2. Don't open up the unit and
send it for repair.
Set the switch of the
connected lamp to On/Off.
1. Check "Manual binding".
Specifications
2. Place the plug closer to the
gateway.
Frequency Range
Remove the load and ensure
Operating Voltage
the connected load does not
Maximum Load
exceed 2000 VA and current
does not exceed 14.5A.
Overload Protection
Protection Degree
Range
** Specifications are subject to change without notice.
3
LED indication Stage
LED blinks 1.During 30 seconds
rapidly for 30 after plugged into
seconds electrical outlet
(blinks every 1
second)
2. After entering Manual
Binding mode
LED blinks 1. More than 30 seconds
slowly for a have passed after
long period. plugging into electrical
(blinks every 2 outlet
seconds) 2. After reset to factory
default
LED turns On After short button press
LED turns Off After short button press
LED flashes After plug turns on the
rapidly for 30 load
seconds
868MHz (EU)/ 923MHz (America)
230V/50Hz
2000 Watts
2200 Watts (±1%)
IP20
70 meter min. line of sight
Explanation
The Plug enters Binding
mode for 30 seconds to bind
with Gateway.
If binding is successful, the
LED will turn on for 1 second
then off.
If binding fails, the LED
flashes rapidly for 3 times at
the end of 30 seconds.
Binding with Gateway has
failed. The Plug is still in
factory reset status.
The Plug is in factory reset
status.
Plug turns on the load.
Plug turns off the load.
Indicates overload protection
is activated.