Petsafe PIG20-11041 Manual De Funcionamento página 4

Two Colour LED
The two colour LED indicator shows good or
low battery. Good battery equals 1 fl ash every
60 seconds with Green LED. Low battery
equals 3 fl ashes every 60 seconds with the
Red LED. If there are no LED lights it is time
to change the battery.
To Set the Static Correction Level
Read all steps before attempting to set the
Static Correction Level.
1. With the battery installed, press the
Correction Level Button and release when
the Receiver Indicator Light lights
red (E).
2. The Receiver Indicator Light will emit a
number of red fl ashes representing the Static Correction Level (F).
3. Increase the Static Correction Level by pressing and releasing the
Correction Level Button within 5 seconds of the previous fl ashes.
The Static Correction Levels increase from 1 to 5. Pushing the Correction Level
Button while the Receiver Collar is on level 5 will cause the Receiver Collar to
revert to level 1. Refer to the Function and Response Table to choose the Static
Correction level that best fi ts your pet.
The Receiver Collar is equipped to automatically increase the level of Static
Correction the longer your pet remains in the Static Correction Zone if the
collar is set at level 2 or above.
The Receiver Indicator Light acts as a low battery indicator, fl ashing every 60
seconds when battery replacement is required. Test your Receiver Collar at least
once a month to verify that it is functioning properly. Check that it activates at the
Boundary Wire.
Over Correction Protection
In the unlikely event that your pet "freezes" in the Static Correction Zone, this
feature limits the static correction duration to 30 seconds. The system locks out
further static correction until the pet leaves the Static Correction Zone.
4 www.petsafe.net
E
F