Steps - Haverland i2Control Manual De Instalacion Y Uso

2.3 Steps :

1) It is essential that the heater IS FIRMLY FIXED TO
A FIRM WALL AND LEVELLED.
2) Remove the template indicating the drill holes from
the packing case.
3) Check if there is a mains socket near the heater
location.
BRACKETS
4) Insert the four 8-mm diameter wall plugs into the
four drill holes and fix the two brackets to the wall
with the four 5.5 x 50 mm screws.
Page 30
TEMPLATE
5) Screw the two M6 x 40 screws into each bracket.
2 SCREWS
M. 6 x 40 mm
6) Position the heater on the lower part of the
brackets.
7) Secure the heater to the upper parts of the
brackets:
Position and secure the heater
on the upper part of the brack-
ets in the corresponding lugs.
Press downwards to fit into
place.
8) Fully screw in the two M6 x 40 mm screws to fix
the heater to the wall.
SCREWS
5,5 x 50 mm