Publicidad
D
o
i
igital
Perating
nStructionS cont
5. Turning unit off:
a. To turn the unit off, press the standby button. The speed and time displays
will be blank, the standby indicator light will illuminate. The Orbital/Microplate
Shaker should be kept in standby mode when not in use. To completely cut off
power to the unit, disconnect the power cord from the unit or unplug from the
wall outlet.
OPERATING TIPS
As a safety feature, a built-in program will shut power off to the motor if the tray is
prevented from rotating, or the unit is overloaded beyond its recommended weight
capacity.
Built-in memory maintains the last used speed and time settings during a power
interruption.
'
D
a
o
S
o
nalog
rbital
haker
Perating
The Standard Orbital Shaker is used for general laboratory shaking needs.
Shaker, Light Duty, SHLD0415AL
1. Getting ready:
a. The speed knob should be at their extreme counter-clockwise position or at the
#1 on the dial.
b. Make sure the rocker switch is in the off position.
c. Plug the cord into a properly grounded outlet.
2. Setting speed:
a. To run push rocker to the on or position. Set speed knob to desired setting
and adjust if necessary. Unit will run until you move the rocker switch to the off
position. The microprocessor speed control slowly ramps to set speed to avoid
splashing.
3. Turning unit off:
a. To stop shaking function, turn the speed knob to the extreme counter-clockwise
position and push the rocker switch to the standby position. The shaker should
be kept in the standby position when not in use. To completely cut off power to
the unit, disconnect the power cord from the unit or unplug from the wall outlet.
OPERATING TIPS
Centering your sample and even weight distribution on the tray helps with balance
and stability.
The shaker will automatically restart after a power interruption.
i
nStructionS
EN
10
Publicidad
