Publicidad
Idiomas disponibles
Idiomas disponibles
3. Installing the Network-Mediaplayer NMP-2000
"Connect ..." TV set „
MOS components
Avoid damage by electrostatic charging.
Observe the rules for handling MOS components.
In the installation instructions which follow, the
"Network-Mediaplayer NMP-1000 / NMP-2000" will only be referred to as "old modu-
le or new module".
A module (NMP-1000/ old module) is installed in the TV set.
This is replaced by a new module (NMP-2000/ new module).
Procedure
See the fi gures on pages 28 to 33.
Disconnect the mechanical and electrical connections.
As a technician you will immediately recognise the mechanical connections (e.g.
screws) and electrical connections (e.g. plugs) to be disconnected.
Remove old module
Special feature of Connect 32
Unscrew the external antenna from the old module and screw onto the NMP 2000.
See page 28 and 29.
Special feature Connect 37 / 42
Take care when opening and removing the cable tie, see fi g. 6, 8 and 10, circle.
Make sure that the cables are not damaged.
Install new module
Fix the antenna cable with the Fastex twister to the 11-wire cable, see fi g. 7, 9, and
11, circle.
Special feature of Connect 42
Remove the adhesive tape and reposition it as shown in fi g. 11, page 33. This prevents
emergence of light and clinking of the ferrite.
In the Connect 42 TV, you fi x the antenna additionally with the cable clip, see fi g. 11,
page 33.
You need the cable clip with screw for the Connect 42.
Check the connections again after installation.
14
Publicidad
