Standard Equipment; Pre-Operation Inspection; Set-Up And Operating Instructions - RIDGID RE 600 Serie Manual De Instrucciones

Die/Electrical Connector Compatibility Charts for these
tools with various heads.

Standard Equipment

Refer to the RIDGID catalog for details on equipment
supplied with specific tool catalog numbers.
Selection of appropriate materials and joining
NOTI E
methods is the responsibility of the system designer and/or
installer. Before any installation is attempted, careful eval-
uation of the specific service environment requirements
should be completed. Consult connector manufacturer
for selection information.

Pre-Operation Inspection

Daily before use, inspect your electrical tool and cor -
rect any problems to reduce the risk of serious in jury
from electric shock, crushing injures, equipment
failure and other causes, and prevent tool damage.
1. Remove battery from tool.
2. Clean any oil, grease or dirt from the tool and head,
including handles and controls. This aids inspection
and helps pre vent the tool or control from slipping from
your grip.
3. Inspect the electrical tool for:
• Proper assembly, maintenance and completeness
(See Figures 1-3).
• Any broken, worn, missing, misaligned or binding
parts.
• Presence and readability of the tool and battery
warning labels.
• Any other condition which may prevent safe and
normal operation.
If equipped with the QCS Coupling, inspect for:
• Foreign material in the QCS coupling (see Main-
tenance section).
• Confirm that all retaining balls are present in all
openings and that there is no damage. Figure 8
shows the inside of a complete and clean QCS
coupling.
• When inspecting the mating QCS coupling on
interchangeable heads, dimples in the grooves
of the QCS coupling are normal with use and are
not considered damage (Figure 9).
999-999-463.10_REV. H
Find Quality Products Online at:
WARNING
GlobalTestSupply
www.
RE 6/RE 60/RE 600 Electrical Tools
Figure 8 – Inside of QCS Coupling
Figure 9 – Dimples in QCS Coupling Grooves
If any problems are found, do not use the tool until the
problems have been repaired.
4. Inspect and maintain any other equipment being used
per its instructions to make sure it is functioning prop-
erly. Inspect the heads for wear, deformation or other
issues.
Set-Up And Operating
Instructions
WARNING
Keep your fingers and hands away from the tool
head during the operating cycle. Your fingers or
hands can be crushed fractured or amputated in the
head or tool or be tween the tool head, work piece
and other objects.
Do not use on energized electrical lines to reduce
the risk of electrical shock, severe injury and death.
Tool is not insulated. Use appropriate work proce-
dures and personal protective equipment when
working near energized electrical lines.
.com
sales@GlobalTestSupply.com
Retaining
Balls
Dimples
Acceptable
7