Master TENTEvent125 Serie Manual De Instrucciones página 8

ASSEMbLY ITEMS
Before assembling heater, make sure you have the items listen below.
•. Phillips.head.screwdriver
•. Wrench
•. Hardware.packet
. Handles.(2),.3/4".Screws.(4),.1/4-20.Nuts.(4),.1/4.Flat.washers.(4),.1/4.Lock.washers.(4)
. Casters.(2),.3/8".Nut.(2),.3/8.Lock.washers.(2),.3/8.Flat.Washers.(4)
. Wheels.(2),.Push.Caps.(2)
Brackets (4), 1/2" black screws (8), 3/8" screws (8)
Note: Place metal parts on packaging during assembly to protect from scratches.
Side Handles
1.. Remove. handles,. 3/4". screws,. 1/4-20.
nuts, 1/4 flat washers and 1/4 lock wash-
ers.from.hardware.packet.
Casters
1. Remove casters, 3/8 flat washers, 3/8
lock.washers.and.3/8.nuts.from.hardware.
packet.
2.. You.may.wish.to.remove.side.panel.from.
heater.to.make.installing.casters.easier..
If.so,.see.Top and Side Panel Removal
on. page. 13.. Figure. 4. shows. side. panel.
removed.for.clarity.
3.. Use. a. spacer. to. prop. end. of. heater. up.
so.holes.in.base.can.be.accessed.(the.2.
wheels.stacked.on.top.of.each.other.will.
accomplish.this).
4. Place a flat washer onto threaded stem of
caster..Insert.caster.stem.through.hole.in.
cabinet.base.as.shown.in.Figure.4.
5. Attach each caster to base with a flat
washer,.a.lock.washer.and.a.nut.as.shown.
in.Figure.4.
8
aSSeMBLy
2.. Attach.each.handle.to.side.panels.with.2.
Figure 3 - Attaching Handles
www.desatech.com
screws, 2 nuts, 2 flat washers and 2 lock
washers.. Insert. screw. from. outside. of.
heater.and.through.handle..From.inside.
of heater, attach a flat washer, then a lock
washer.then.a.nut.as.shown.in.Figure.3.
Nut
Lock.Washer
Flat.Washer
Nut
Lock.Washer
Flat.Washer
Caster
Figure 4 - Installing Casters
Handle
Screw
120193-01A