Inserting And Replacing Batteries; Weather Station; Rain Gauge - OWIM H13726 Instrucciones De Utilización Y De Seguridad

Inserting and replacing batteries

9. Inserting and replacing batteries
Put the batteries first into the outdoor
sensor (wind gauge / rain gauge), then
into the weather station.

Weather station:

– Open the battery compartment on the rear of
the weather station in the direction of the arrow.
– Insert the batteries (6 x 1.5 V type AA) ensuring
correct polarity. When one of the two battery
rows is full, a beep sounds.
– Place the battery compartment cover on the
battery compartment to close. Push the battery
compartment cover in the opposite direction to
the arrows until it engages.
Wind gauge:
– The wind gauge must be recalibrated when using
it for the first time as well as every time the battery
is replaced. Please refer to section 11.1. To open
the battery compartment, loosen the 4 cross-head
screws on the battery compartment cover.
– Lift off the battery compartment cover.
– Insert the batteries (2 x 1.5 V type AA) ensuring
correct polarity. Ensure that the black strap lies
under the batteries. This strap can be used to
remove the batteries when they need to be re-
placed.
– Place the battery compartment lid on the bat-
tery compartment again. Ensure that the sealing
ring on the battery compartment is positioned
correctly in the recess. Only then is the battery
compartment waterproof.
– Tighten the 4 screws on the battery compart-
ment cover again.
70 GB/MT

Rain gauge:

– Use a slotted screwdriver to loosen the 2 adja-
cent fastening screws on the housing of the rain
gauge.
– Lift the housing carefully off the base of the device.
– To open the battery compartment, loosen the
4 cross-head screws on the battery compart-
ment cover.
– Lift off the battery compartment cover.
– Insert the batteries (2 x 1.5 V type AA) ensuring
correct polarity.
– Place the battery compartment lid on the battery
compartment again. Ensure that the sealing ring
on the battery compartment is positioned cor-
rectly in the recess. Only then is the battery
compartment waterproof.
– Tighten the 4 screws on the battery compart-
ment cover again.
– Place the housing carefully over the base of the
device.
– Fix the housing onto the base of the device
again with fastening screws.