Keep Out SX200 Manual Del Usuario página 59

EN
1.Steps 1 and 2 as HDMI connection
2.Connect adapter composite video (yellow video cable and red and white audio cord) and plug it into the console video
with their respective cables.
3.Steps 4,5,6 connection like HDMI
Operating process
Once connected, you will see the green indicator record button on.
To record the video it is very simple --- press the record button, then you will see the indicator change to solid red, it means
that recording is in process.
To stop recording, press the button again, the indicator will blink for a few seconds and then turn green, it means that the
recording has finished, now you can remove your USB stick or SD card.
Note: Please do not remove the USB memory or SD card when the indicator is flashing. Recording will stop automatically
if the USB or SD flash card have no free space.
After stopping the recording, connect the USB flash drive or SD card to the computer you will see the recorded files: 1080P
for recording, the file will Encode_1080P_1, 720 or 480p recording, file will Encode_1.
Each recording operation / stop create a different recording file: Encode_1080P_1, Encode_1080P_2, Encode_1080P_3 ...
and so on.
The maximum size per file will be around 1.95GB (about 15 minutes to 1080p video), recording a video more than 1.95GB
(15 minutes), the files are distributed in more than one file, for example: if you record a 45 minutes of 1080p video
recording by clicking, you will see 3 files: Encode_1080P_1, Encode_1080P_1_1, Encode_1080P_1_2 ... etc.
Always remove the USB memory or SD card safely from your PC, otherwise you may lose the recorded information.
Firmware Update and Other Functions
1.Firmware update: You may need to update the firmware of this device for some reason. Download from the website the
latest firmware available. Copy the firmware file on the USB drive or SD card, turn off the device (power connector, unplug)
Connect the USB memory device or SD card, connect the power, the indicator flashes between 7 and 8 seconds, and when
changing to green, it means that the update is complete.
2.After a long time using the device, you will see the number of recording files become too large, for example
Encode_1080P_234 but it wants to start from Encode_1080P_0, reset by holding the record button (before turning on the
device) then connect the power connector to power the device, after 3 seconds, the file number will start from
3.Change the date: it is possible that the date of the recorded file is not synchronous with the local time. To change the
device time it is necessary to create a TXT file name "rtc_setup" enter your local date and time with this format (for example
July 31 2015 11:00:00):