U.S.Robotics R24.0442.00 Guia De Instalacion página 9

I am unable to enter the 802.11g Wireless Turbo Multi-function Access Point Web Configurator.
Possible Solution:
Be sure that the 802.11g Wireless Turbo Multi-function Access Point has a valid IP address and is
on the same network as your computer.
My 802.11g Wireless Turbo Multi-function Access Point is not appearing in the list when I scan
for it.
Possible Solution:
You may be on a computer that is physically too far away from the 802.11g Wireless Turbo Multi-
function Access Point. Try moving closer to the 802.11g Wireless Turbo Multi-function Access
Point and repeating the scan procedure. Check any physical connections between the 802.11g
Wireless Turbo Multi-function Access Point and your modem, router, hub, LAN, or switch.
My computer is not acknowledging my 802.11g Wireless Turbo Multi-function Access Point.
Possible Solution:
Be certain that the 802.11g Wireless Turbo Multi-function Access Point is plugged into a power
source and is properly installed. Make sure the Ethernet cable is securely connected to the Ether-
net port on the 802.11g Wireless Turbo Multi-function Access Point and to the Ethernet port on
your cable or DSL modem, router, hub, or switch.
I am experiencing poor link quality in some areas of my home or office.
Possible Solution:
You might be encountering interference from walls or other structures that is lowering your link
quality. Try placing your 802.11g Wireless Turbo Multi-function Access Point at a higher location,
such as a higher shelf, or repositioning it in a different area of your room or office.
I accidentally clicked Cancel during the installation procedure.
Possible Solution:
Remove and reinsert the U.S. Robotics Installation CD-ROM into your CD-ROM drive. Repeat the
installation procedure of the software before you install any hardware.
The installation procedure did not begin when I inserted the Installation CD-ROM.
Possible Solution:
Some programs may keep the autolaunch feature of the Installation CD-ROM from beginning.
Close any open applications and reinsert the Installation CD-ROM.
The 802.11g Wireless Turbo Multi-function Access Point is not receiving any power.
Possible Solution:
Make sure the power supply of the 802.11g Wireless Turbo Multi-function Access Point is con-
nected to the power jack on the 802.11g Wireless Turbo Multi-function Access Point and to a stan-
dard power outlet.
5