Honeywell Prestige IAQ Guia De Instalacion página 2

2-wire Prestige® IAQ and RF EIM
Mount and wire thermostat
1
Pull wiring through hole in wall plate and install as shown below.
Strip 1/4" insulation and connect wires to screw terminals as shown.
Drywall: 3/16" hole
Plaster: 7/32" hole
Connect the two wires from the thermostat to the Equipment Interface
Module R and C terminals or to a separate 24 volt transformer (not pro-
vided).
Wiring must comply with local electrical codes.
Mount and wire Equipment Interface Module
2
Use screws & anchors (not included) as appropriate for mounting surface.
Mount Equipment Interface Module on wall near HVAC equipment, or on
the equipment itself.
Do not install inside HVAC equipment.
69-2445EFS—03
Wall anchor
Mounting
screw
MCR32386
MCR32388
MCR29241
Strip 1/4" insulation, then insert wires as shown.
2
MCR32387
MCR32389