Level 3 - CARLO GAVAZZI T2000 Serie Manual De Instrucciones

SP2 OPERATING MODES
(see page 6)
Function Options
SP2.A [nonE] dV.hi dV.Lo bAnd FS.hi FS.Lo Cool
Main SP2 operating mode
SP2.b [nonE] LtCh hoLd nLin
Subsidiary SP2 mode: latch/sequence
Non-linear cool proportional band
INPUT SELECTION AND RANGING
dI.SP [1] 0.1
Select display resolution: for display of process temperature, setpoint, OFSt, Set.2, hi.SC,
LoSC.
hi.SC sensor minimum [sensor maximum]
°C/°F
Set full scale
Lo.SC [sensor minimum] sensor maximum
°C/ºF
Set scale minimum (default 0°C or 32°F)
inPt Select input sensor [nonE]
(See SENSOR SELECTION table, page 11)
unit [nonE] °C °F bAr Psi Ph rh SEt
Select °C/°F or process units

LEVEL 3

LEVL 3
OUTPUT CONFIGURATION
Note: 'Read only' after initial configuration. rSET ALL full reset to factory settings required
to change SP1.d subsequently.
SP1.d [nonE] rLY SSd rLY1 rLY2 SSd1
Select SP1 output device
SP2.d [nonE] SSd rLY rLY2 rLY1 SSd2
Read SP2 output device
(read only)
Dual Relay and Dual SSd output options are factory set.
8
Note: (when in initial configuration only)Hold
to or from output devices in shaded portion.
[Factory settings] shown in brackets
and or for 10 seconds to move
burn Sensor burn-out/break protection
Caution: Settings affect fail safe state.
[uP.SC]
dn.SC
1u.2d
1d.2u
rEu.d Select output modes: Direct/Reverse
Caution: Settings affect fail safe state.
[1r.2d]
1d.2d
1r.2r
1d.2r
Select Reverse on SP1 for heating and Direct for
cooling applications.
rEu.L Select SP1/2 LED indicator modes
[1n.2n]
1i.2n
1n.2i
1i.2i
SPAn [0.0] to ±25% sensor maximum
Sensor span adjust
For recalibrating to align readings with another instrument e.g. External Meter, data logger.
See Full Operating Manual (ADVANCED SETTINGS).
ZEro [0.0] to ±25% sensor f/s
Zero sensor error (see Sensor span adjust above).
ChEK [oFF] on
Select control accuracy monitor
rEAD [ Var] hi Lo
Read control accuracy monitor
[ Ct A]
tECh CT b Ct 1 Ct 2 Ct 3 Ct 4
Read Autotune tuning cycle data (see Operating Manual)
UEr Software version number
rSET [nonE] ALL
Resets all functions to factory settings
Caution: This selection will lose all of the current settings.
SP1 SP2
Upscale Upscale
Downscale Downscale
Upscale Downscale
Downscale Upscale
SP1 SP2
Reverse Direct
Direct Direct
Reverse Reverse
Direct Reverse
SP1 SP2
Normal Normal
Invert Normal
Normal Invert
Invert Invert
oS 1 uS oS 2