Set Inputs; Polarity (On Standby); Message To Send; Numbers To Call - Bentel Security BGSM-A Guía De Introducción

2. Enter the Message description (maximum
20 characters).
z z z z z Set Inputs
Using this table, program the parameters of
each Input:
„

Polarity (on Standby).

Select whether the Input is to be activated by:
(á á ) - Positive signals or
á á á
(â â ) - Negative signals
â â
â
Click the relevant Input Polarity field to toggle
the status.
NOTE - The settings in this page will upda-
te automatically the corresponding set-
tings in the SMS Dialler Page.
„
Message to send. Triple click the Input
Message field, click
Message list, then select the message.
„

Numbers to call

Click (9 9 9 9 9 ) the check boxes (1, 2, 3, 4, 5, 6, 7, 8)
of the numbers to call, in the event of an Alarm.
Click once to toggle the status.
SERV. If this function is enabled (9 9 9 9 9 ), Alarm
„
conditions on the relative channel will not gene-
rate Alarm signals or calls, but will activate SER-
VICE mode. If this function is enabled for Chan-
nel 1, any ongoing calls will be interrupted. If this
function is enabled for Channel 2, 3 or 4, any
ongoing calls will be interrupted at the end of the
Call cycle. Activation of Service mode will block
all Outputs, and will be held until the channel is
restored to Standby. Click the relative SERV field
® ®
Figure 9 - Dialler Page
to open the dropdown
to toggle (Enable/Disable) the status.
NOTE: The setting in this page will upda-
te automatically the corresponding set-
ting in the 'SMS Dialler' page.
„ „ „ „ „

Switch to GSM

If this function is utilized, the message indica-
ted in the 'Message' field corresponding to Input
No. 4 will be irrelevant.
Only - If you enable this option (9 9 9 9 9 in the box
corresponding to Input No. 4), the BGSM-A will
switch to the GSM network for a full 15 minute
interval when unbalancing occurs on Input
No. 4. At the end of the interval, it will check
the PSTN line:
—if restored, it will switch back to the PSTN;
—if not, it will remain connected to the GSM
Network for a further full 15 minute interval.
This operation will be repeated until the PSTN
line is fully restored.
Dial - If you enable this option (9 9 9 9 9 in the box
corresponding to Input No. 4), the BGSM-A will
perform as per the Only option and, if the line
connected to the LI terminals of the BGSM-A
is busy (see Tab. 5) when unbalancing oc-
curs on Input No. 4, it will send a call to Tele-
phone Number 1 (if duly programmed).
NOTE - This setting updates the same pa-
rameters in the corresponding "Dialler"
page.
33