Switch To Gsm; Outputs Page; Polarity (On Standby); Set Output Columns - DSC GS3050-A Manual Del Operador

ges will be sent to the selected ( ) Telephone
numbers, when Events occur/end on the as-
sociated Input. Click once to toggle the status.

Switch to GSM

Refer to Switch to GSM in the Dialler Page sec-
tion. If this option has been programmed, Input No. 4
cannot be programmed to manage SMS texts.
O P
UTPUTS AGE
This page (see Figure 11) will allow you to select
the Output Polarity; assign the Events to the
Outputs; and program the Reserved Outputs, Te-
lephone Access Code and SMS Strings for remo-
te control (over the phone).

Polarity (on Standby)

(á á ) Normally Closed: no signal (floating)
á á
á
will be present on N.C. Output terminals during
Alarm status. However, if a Pull-Up resistor is
connected, a Positive signal will be present.
(â â ) Normally Open: a Negative signal will
â â
â
be present on N.O. Output terminals during
Alarm status.
Click once to toggle the status.

Set Output Columns

Click ( ) the check boxes of the Events that
will activate the corresponding Output, in the
event of an Alarm.
NOTE - Each Output can manage more
than one Event. All seven Events must be
assigned to the Outputs. Each Event can
be assigned once ONLY.
Figure 11 - Outputs Page
16
Output Reserved
Click the check boxes of the Outputs that will
be dedicated to Remote Telephone Control.
Reserved Outputs can be accessed ONLY
over the phone, via the Telephone Access
Code.
NOTE: If you set up an Output as Reser-
ved, any selected events will be cleared
automatically.

Control SMS

Program the SMS text that will turn ON the
Reserved Output in this field.
The chart in Figure 10 shows the the letters
(without accents), numbers and punctuation
marks that can be used.
Each message can contain 10 characters (DO
NOT put spaces between letters).

SMS Telephone Access Code

Enter the Telephone Access Code (max. 4 di-
gits) in this field. For further information refer
to the 'Outputs Page'.
C P
ALL AGE
This page (see Figure 12) will allow you to view
the list of Received, and Missed calls.
To view call records:
1. Click the Load button (loading takes several
seconds).
If the system has received several calls from
the same Telephone number, ONLY the last
call will be listed.
GS3050-A - GSM Dialler and Interface